New Controller in the works

fucking machine controller

New Fucking Machine Controller

I have been working on another controller for my fucking machine. The original is still a great controller that allows the user to produce the finest detail in motion and a range from slow and gentle to extreme. The original controller requires continuous user control.

The new controller is intended for either automatic operation or mixed automatic/manual control. The picture is of a prototype so the buttons and dials are not yet labeled. The controller contains a 32 bit 80 MHZ microcontroller so it can be programmed to do almost anything. It will be possible to store hundreds of different fucking scenarios in the controller’s flash memory and these may be selected from menus displayed on the LCD. Control buttons and dials may change function depending on the needs of the particular scenario.

Currently, the buttons operate as follows:  Button one starts pauses and resumes fucking machine operation. Button two returns the actuator to the home or fully retracted position. The three dials set the stroke speed, the stroke length and the offset from the home position. All three dials may be operated while either running or when paused.

The stroke control dial allow the actuator to cover the entire range of the machine or any part of it. The speed dial allows for anything from very slow motion to a very high speed. When speed is set at a fast rate and the stroke is set at a low rate, the fucking machine operates in vibrator mode at a speed as high as 100 HZ.

While in vibrator mode (or any other mode as well) the actuator position may be varied with the third dial. This allows for simultaneous vibration and thrusting. Future selectable scenarios will include vibration on various stroke patterns as well as anything I can think of that might be fun. Please suggest anything that you think could be enjoyable.

This entry was posted in Uncategorized. Bookmark the permalink.

4 Responses to New Controller in the works

  1. Mike says:

    I would love more info on this controller

    • shagmatic says:

      This controller is going to be redundant soon. I am working on PC application that gives a PC the ability to communicate with the fucking machine. It will have record and playback capability as well as the ability to do all that this controller does and much much more.

  2. bob oliver says:

    would like info on when ready to buy and the diy kit mostly. please send info . Thank you

    • shagmatic says:

      the DIY kit should be available soon. Once I have the record function working (which I hope will be very soon) I will start on the documentation for the kit and will build one following the instructions. I am looking for a few people with basic wood working skills for beta testing. Contact me if you are interested.

Leave a Reply

Your email address will not be published. Required fields are marked *